CMDIY Base Map

Drive by Wire

Classic Mini DIY is proud to offer the Bad Wolf DBW Turbo Map to all customers. This is the generic version of the exact map used on my car during the Turbo Drive by Wire conversion on my youtube channel.

Who is this For?

Drive By Wire Conversions

This is a complete map including base ignition, and fueling tables, as well as a starting point for a closed loop throttle map.

Intended to help fast track your car from assembly to the dyno for complete tuning.

Base Map

Whats included?

Haltech ECU Base Map from Bad Wolf Mini

The map comes with the following pre-configured:

  • Starting Point Idle Map
  • Starting Point Ignition Timing Map
  • Starting Point VE Table
  • Starting Point Target Lambda
  • Starting Point Throttle Enrichment
  • Tailored to work with CMDIY DBW Throttlebody

Disclaimer

THIS IS NOT A PLUG-AND-PLAY MAP

You must get your car to a dyno to have it properly set up after
installing this map or you can cause catastrophic damage to your
engine. 

Drive by Wire Turbo | Classic Mini Base Map - Classic Mini DIY

Drive by Wire Turbo | Classic Mini Base Map

Regular price$2,823.00
/

  • Ships Worldwide
  • Note: All Base map sales are non-refundable

Classic Mini DIY is proud to offer the Bad Wolf DBW Turbo Map to all customers. This is the generic version of the exact map used on my car during the Turbo Drive by Wire conversion on my Youtube channel.

What you get:

Haltech ECU Base Map from Bad Wolf Mini

The map comes with the following pre-configured:

  • Starting Point Idle Map
  • Starting Point Ignition Timing Map
  • Starting Point VE Table
  • Starting Point Target Lambda
  • Starting Point Throttle Enrichment
  • Tailored to work with CMDIY DBW Throttlebody
  • FREE UPDATES FOREVER

NOTE: THIS IS NOT A PLUG-AND-PLAY MAP. You must get your car to a dyno to have it properly set up after installing this map or you can cause catastrophic damage to your engine. 

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

FAQs

Currently this map is designed using a Nexus R3 however it will work with any Haltech ECU that supports Drive By Wire.

Including but not limited to:

  • Elite 1500
  • Elite 2500
  • Nexus R3
  • Nexus R5

This map is designed to get your car running at idle and running after a rebuild. Also for knocking in your cam and doing initial startup. This is not a tune to allow you to drive your car and put load on the engine. After using this map, you must have your car mapped by a professional dyno.

This map is not designed to get you to a specific power figure. Any power runs, or power targets should be done by a professional at a dyno.

CMDIY does provide email support for general questions on this map and its configuration. However we do not offer any tuning services, nor will we provide in depth electrical or technical guidance on your specific EFI system.


Recently viewed